Advertisement
Console w/Clutch Control -
Seed Shaft Sensor - Optional
Seed Shaft Sensor and Magnet Wheel Assembly
Installation
1. Remove the two #10-24 x 3/4 Self Tapping Screws
from the Magnet Wheel Assembly.
2. Position half of the Magnet Wheel Assembly on the
Seed Shaft. Ensure it fits squarely onto Seed Shaft.
3. Mount the other half, ensuring it fits squarely onto
Seed Shaft.
4. Fasten the two halves together using two #10-24 x 3/4
Self Tapping Screws. Do not over tighten.
5. Identify the Seed Meters on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware.
6. Insert Seed Shaft Sensor into Shaft Sensor Bracket
Slot. See Figure 2-40.
7. Align the Shaft Sensor Bracket with the two 1/4-20
Bolts. Secure with existing Lock Washers and Nuts.
Machine Screw,
1/4-20 x 3/4
Screw,
Self Tapping
#10-24 x 3/4
Seed Shaft
Sensor
Shaft Sensor Bracket
9K998-2306
TABLE OF CONTENTS
Seed Shaft
Magnet Wheel
Assembly
11/16 Hex Shaft
Existing Lock Washer,1/4-20
Existing Nut,1/4-20
Figure 2-40: Console w/Clutch Control Seed Shaft Sensor
8. Position Seed Shaft Sensor so it is 1/8" from the
Magnet Wheel Assembly. See Figure 2-39. Tighten
both Seed Shaft Sensor Retaining Nuts.
Magnet Wheel
Assembly
Magnet
Figure 2-39: Console w/Clutch Control Detail
Seed Shaft
Magnet Wheel
Assembly
11/16 Hex Shaft
Existing
Lock Washer,1/4-20
Existing
Nut,1/4-20
Shaft Sensor
Bracket
Seed Shaft
Sensor
Retaining Nuts
1/8" Max
Machine Screw,
1/4-20 x 3/4
Screw,
Self Tapping
#10-24 x 3/4
Seed Shaft
Sensor
Shaft Sensor
Bracket
2-25
Advertisement
