Advertisement
Scraper Kit, Tube Mounted -
Optional
IMPORTANT
Cannot be used with Coil Tine Track Remover Kit.
NOTE
If Seeder has been used, check Front Roller Assembly
Wheels that they are tight to one another before installing
Scraper Kit. See "Front and Rear Roller Adjustment"
on Page 4-5.
1. Lower implement onto level ground.
2. Position and assemble the Brackets with the 4-Hole
Plate approximately as dimensioned on the front of
the Seeder Frame Tube. See Figures 2-64 and 2-65.
Secure with 1/2-13 x 4-1/2 x 7-1/2 U-Bolts and
Flanged Locknuts.
NOTE
Scraper Brackets should be positioned per application.
Use Figures 2-64 and 2-65 only as a reference.
•
12FT Machines with Drawbar Braces:
Mount the Brackets with the 4-Hole Plate to the
Drawbar Brace Plates with the Drawbar Brace
Hardware. See Figure 2-60.
•
3rd Bracket:
10FT and 12FT Models require a 3rd Bracket that
is to be installed on the Seeder Frame Tube left of
center in a place that clears the Drawbar or 3-PT
Hitch. See Figure 2-61.
NOTE
S-Tine Tire Track Remover Kit can be used with Scraper
Kit. Do Not mount the outer Brackets with the 4-Hole Plate
to the front of the Seeder Frame Tube. Attach the outer
Scraper Bracket Angle to the Tire Track Remover Kit
S-Tine Bracket Tube with a 1/2-13 x 4-9/16 x 3-1/4 U-Bolt
and Flange Locknuts. See Figure 2-62.
3. Attach the Scraper Brackets to the Bracket Tube with
a 1/2-13 x 4-9/16 x 3-1/4 U-Bolt and Flange Locknuts.
Do Not tighten at this time. See Figure 2-59.
2-36
TABLE OF CONTENTS
Seeder Frame
Tube
Locknut,
Flanged,1/2-13
Drawbar
Brace Plate
Bracket with
4-Hole Plate
Figure 2-60: 12FT Drawbar with Braces
3rd Bracket with
4-Hole Plate
10FT and 12FT Models Only
Seeder Frame
Tube
Figure 2-61: 3rd Bracket Placement - 10' & 12'
U-Bolt,1/2-13 x
Bracket with
4-Hole Plate
Figure 2-59: Scraper Brackets
Seeder Frame
U-Bolt,1/2-13 x
Tube
4-1/2 x 7-1/2
Locknut,
Flanged,1/2-13
U-Bolt,1/2-13 x
4-9/16 x 3-1/4
Scraper Bracket
4-1/2 x 7-1/2
Locknut,
Flanged 1/2-13
Drawbar
9K998-2306
Advertisement
