Advertisement
Latch Installation
Large Seed Box Cover with Latches and Gas Springs
1. Place the gasket on latch base and place on Seed
Box Cover.
2. Install slotted screws to secure Latch to Cover.
3. Thread the nut onto latch rod, then slide on Internal
Tooth Washer, Pawl, the other Internal Tooth Washer
and then thread on the other nut. Hand tighten only.
Close the Cover and turn Latch to see if Pawl fits snug up
against seed box lip. If it does not, open Cover and adjust
nuts accordingly. When properly adjusted, securely
tighten latch nuts.
Slotted Screws
Latch Pawl
Ball Stud
Locknut,5/16-18
Gas Spring
Mounting Bracket
Gas Spring
Rod end must
be down
2-14
TABLE OF CONTENTS
Cover Gas Spring Installation
NOTE
Gas Spring rod end must be down for proper
functionality.
1. Snap Gas Spring rod end onto Seed Box Gas Spring
Bracket.
2. Swing Gas Spring base end up to Cover Ball Stud and
snap in place.
Gasket
Latch
(2) Slotted
Screws
Latch
Gas Spring
Figure 2-20: Latch Installation
(2) Internal
Tooth
Washers
(2) Nut
Pawl
Cover
Gas Spring
Pawl
(Closed Position)
Bolt,1/4-20
x 1/2
9K998-2306
Advertisement
