Advertisement
27. Install Front Seed Shaft Coupler and tighten Rear
Seed Box Feed Roll Coupler Assembly Set Screws
against the Seed Shaft and tighten Jam Nuts against
Feed Roll Coupler.
28. Tighten the Transmission #40 Drive Chain Idler
Sprocket Clevis Drawbolt Locknut to apply tension to
the Drive Chain and secure by tightening the Axle
Bolt. See "Transmission (Before 01/2020)" on
Page 5-7.
Bolt,5/16-18
x 1-1/4
2-34
TABLE OF CONTENTS
Bearing Carrier
RH Seed Shaft
Nut,1-8
Figure 2-58: Rear Box RH End Assembly
29. 8FT and 10FT Seeders: Install RH and LH Light
Brackets.
12FT Seeders: Install Turnbuckles to Double Box RH
Support, Double Box Center Bracket and LH Double
Box Mounting Plate.
30. Connect Acre Meter and Warning Lamps.
RH Double Box Support
Bolt,5/16-18 x 1
Flat Washer,5/16
Lock Washer,5/16
Nut,5/16-18
Bearing
Lock Washer,
5/16
Nut,5/16-18
Adjusting
Screw
Flangette
Seed Rate
Adjusting Nut
Locknut,1/2-13
9K998-2306
Advertisement
