Advertisement
Warning Lamps
When plugging in the 7-Pin Warning Lamp Connector:
1. Make sure the Tractor has a good clean Receptacle,
free of dirt and corrosion.
2. Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think the
Connector is all the way in, but it really isn't.
3. Make sure the Tractor Receptacle Cover latches over
the keyway on the 7-Pin Connector to hold the
Connector in place.
If an operator plugs in the 7-Pin Connector, but the lights
do not seem to work right, check the above items to make
sure there is a good connection with the 7-Pin Connector.
Amber
Lamp
Red Lamp
Warning
Lamp Harness
7-Pin/4-Pin
Harness
Figure 5-14: Warning Lamps
5-10
TABLE OF CONTENTS
Amber
Lamp
Flasher Control
Module
Scraper Adjustment
1. Check the Front Roller Assembly Wheels that they
are tight to one another. See "Front and Rear Roller
Adjustment" on Page 5-5.
2. Lower the implement onto level ground.
3. Verify that the Scrapers are centered as best as
possible between the Roller Wheels and adjust if
necessary. See Figure 5-15.
Roller Wheel
Figure 5-15: Scraper Alignment
4. Adjust the Scrapers as needed to achieve a 3/16" to
1/4" gap between the Scrapers and Roller Wheels.
See Figure 5-16. Scrapers should be close enough
to the Roller Wheels to be functional but without
interference.
Scraper
Bracket
Scraper
3/16"
Gap
1/4"
Roller Wheel
Figure 5-16: Scraper Dimensions
Scraper
Bracket with
4-Hole Plate
Seeder Frame
9K998-2306
Advertisement
