Advertisement
Locknut,Flanged,1/2-13
Figure 2-62: Tube Mounted Scrapers with S-Tine Tire Track Remover
4. Center Scraper Tube with the Seeder Front Roller.
5. Center the Scrapers between the Roller Wheels and
attach them to the top of the Scraper Tube in the outer
slots with 3/8-16 U-Bolts and Flange Locknuts. Attach
the Single Scrapers to the end of the Scraper Tube as
needed.
6. Align the Scraper Brackets Slotted Plate to the
appropriate Scrapers and attach with the Scraper
3/8-16 Hardware. See Figure 2-63. It may be
necessary to use the center pair and an outer pair of
slots in the Scraper to attach the Scraper Bracket to
the Scraper and Tube Assembly. See Figures 2-64
and 2-65.
7. Move the Scraper Bracket on the Bracket with 4-hole
Plate Tube until the Scrapers are close enough to the
Roller Wheels to be functional but without
interference, about 3/16" to 1/4" gap between the
Scraper and Roller Wheel.
8. Tighten all 1/2-13 Hardware. Adjustment may be
required after use.
9K998-2306
TABLE OF CONTENTS
S-Tine Bracket
Tube
Scraper Bracket
Scraper Tube
Bracket with
4-Hole Plate
Scraper
Bracket
Single Scraper
U-Bolt,3/8-16 x
2-7/16 x 2-3/4
Scraper Tube
Figure 2-63: Scraper Assembly
S-Tine Bracket
U-Bolt,1/2-13 x
4-9/16 x 3-1/4
Scraper
Seeder Frame
Tube
Locknut,
Flanged,1/2-13
3-Wheel
Scraper
2-37
Advertisement
