Advertisement
Warning Lamp Installation,
8FT and 10FT
NOTE
10FT Drawbar model is shown, 10FT 3-PT, 8FT Drawbar
and 8FT 3-PT models similar.
1. Attach Amber Lamp to the upper portion of the Light
Bracket located at the ends of the Seed Box with
1/4-20 x 1-1/4 Bolts and Locknuts. See Figure 2-16.
2. Attach Red Lamp below the Amber Lamp with 1/4-20
x 1-1/4 Bolts and Locknuts. Ensure Red Lamp Lens
faces rearward.
3. Attach the Flasher Control Module to the Module
Bracket with 1/4-20 x 1-1/2 Bolts and Locknuts.
IMPORTANT
Cords are marked Yellow Tape for Left and Green
Tape for Right.
4. Lay out the Lamp Harness along the Seeder Frame,
Cords with Yellow Tape Left and Cords with Green
Tape Right. Connect the Harness to the Flasher
Control Module 6-Prong Connector.
5. Route the left and right cords along the front of the
Frame Tube up to the outer Light Brackets. Connect
the 2-Prong Connector to the Amber Lamps and the
3-Prong Connector to the Red Lamps.
6. Lay out the 7-Pin Harness along the 3-PT Hitch or
Drawbar with the 4-Prong Connector towards the
Seeder. 3-PT Hitch, route the 4-Prong Connector
Cord through the Frame Loop to the Module.
Drawbar, route the 7-Pin Harness along the Drawbar,
through the Hose Support up to the Tractor. Connect
7-Pin Harness 4-Prong Connector to the Flasher
Control Module.
7. Bundle and secure excess cord to the Module Bracket
with Tie Wraps. Along the Frame, secure Harnesses
with Tie Wraps to the Frame End Plate Slots, Slotted
Tabs and Hydraulic Hoses. Secure the Lamp cords to
the ends of the Seed Box with Adhesive Mounts and
Tie Wraps. Bundle and secure 7-Pin Harness to the
Drawbar Hydraulic Hoses or 3-PT Hitch Frame Slots
allowing enough Harness length to reach the Tractor
Socket.
NOTE
Install, route and secure Electric Clutch Harness with the
Lamp Harness.
2-10
TABLE OF CONTENTS
IMPORTANT
All Harnesses must be firmly attached to Machine
Frame members or Hydraulic Hoses so they do not
sag or become torn loose by field debris.
8. Attach the SMV sign to the SMV Support with 5/16-18
x 1" Bolts, Flat Washers, and Locknuts.
9. Attach the Connector Holder to the Drawbar Hose
Holder or 3-PT Hitch with 1/4-20 x 1 Bolts, Flat
Washers, and Locknuts.
NOTE
The 7-Pin Plug on the other end of the 7-Pin Harness
connects to the Tractor Socket when in use. When not in
use, it can be stored in the Connector Holder on the
Drawbar Hose Holder or 3-PT Hitch. Allow enough
harness length to reach Tractor Socket and roll or fold up
excess and secure to Drawbar Hydraulic Hoses or 3-PT
Hitch.
Bolt,
1/4-20 x 1-1/2
Figure 2-16: Flasher Control Module and Bracket
Module Bracket
Locknut,1/4-20
Flasher Control Module
9K998-2306
Advertisement
