Advertisement
TABLE OF CONTENTS
Transmission (Before 01/2020)
To adjust the Transmission Chain, loosen the 5/8" Idler
Sprocket Axle Bolt and adjust the Clevis Drawbolt Locknut
to obtain about 1/8"-1/4" sag. Re-tighten the Idler
Sprocket Axle Bolt. Be careful not to over-tighten this
chain. See Figure 5-5.
Adjust the #550 Drive Chain between the Front Roller
Sprocket and Transmission by adjusting the Nylatron
Tension Idler to allow approximately 2" of Total Chain
Deflection.
Idler Sprocket
Clevis
Axle Bolt
Drawbolt
1/8" - 1/4" Slack
#40 Chain
Clevis Drawbolt
Locknut
Clutch Shaft
Rear Seed Shaft
Front Seed Shaft
Nylatron
Tension Idler
SL2 OpOldTranyTension
1"
#550 Chain
2" Total
Front Roller
Deflection
Sprocket
Figure 5-5: Transmission (Before 01/2020)
9K998-2306
5-7
Advertisement
