Clutch Replacement - Toro Z MASTER 2000 Series Service Manual

Engine Installation (continued)

Clutch Replacement

Clutch Removal
2000 Series Z MASTER®Service Manual
3460-328 Rev A
g420405
17. Using a 1/2 inch wrench, install the 2 (5/16 inch) nuts to secure the lower
portion of the muffler guard to the chassis.
18. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
19. Lower the machine.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Using a floor jack, raise the rear of the machine and secure with jack stands.
4. Remove the deck belt. Refer to
5. Remove the hydrostatic drive belt. Refer to
(page 7–10).
6. Disconnect the wire harness from the clutch. Release the wire harness from
the mounting clip.
g420385
Figure 29
Deck Belt Removal (page
Figure 30
Page 4–17
5–7).
Hydrostatic Drive Belt Removal
Engine: Service and Repairs