Flush Front Light Replacement - Toro Z MASTER 2000 Series Service Manual

Parking Brake Switch Installation (continued)
Parking Brake Switch Testing

Flush Front Light Replacement

Flush Front Light Removal
2000 Series Z MASTER®Service Manual
3460-328 Rev A
4. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
g427668
The parking brake switch is a single pole plunger type switch (normally open)
with two terminals. When the plunger is depressed (parking brake ON), the
circuit closes and there is continuity between the terminals. This allows battery
voltage to flow to the Smart Hour Meter for the safety interlock system.
•
Parking brake ON, the switch should have continuity (closed).
•
Parking brake OFF, the switch should NOT have continuity (open).
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Using a T30 torx driver, remove the 2 (1/4 inch) bolts securing the front
bumper to the chassis.
Figure 149
Page 8–23 Electrical: Service and Repairs