Ignition Switch Replacement - Toro Z MASTER 2000 Series Service Manual

Light Switch Testing

Ignition Switch Replacement

Ignition Switch Removal
Ignition Switch Installation
2000 Series Z MASTER®Service Manual
3460-328 Rev A
g427667
The light switch is a Single Pole Single Throw switch that supplies battery voltage
to the front light and any added accessory light. When switched on, the circuit
closes, and there is continuity between the terminals.
•
Light switch on ("I") the switch will have continuity.
•
Light switch off ("O") the switch will NOT have continuity.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the control panel. Refer to
4. Compress the 2 tabs on the side of the switch and remove the ignition switch.
1. Insert the light switch into the control panel.
2. Install the control panel. Refer to
3. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 141
Control Panel Removal (page
Control Panel Installation (page
Page 8–17
8–9).
8–12).
Electrical: Service and Repairs