Right Hand Pod Replacement - Toro Z MASTER 2000 Series Service Manual

Left Hand Pod Installation (continued)

Right Hand Pod Replacement

Right Hand Pod Removal
Chassis: Service and Repairs
g421543
3. Using a T30 torx driver, install the 3 (1/4 inch) shoulder bolts securing the
LH pod to the chassis.
g432460
4. Install the 2 retaining clips to secure the fuel filler neck to the LH steering
pod assembly.
5. Install the fuel tank cap from the fuel filler neck.
6. Install the LH handle assembly. Using a 9/16 inch wrench, install the 2 (3/8
inch) bolts to secure the LH handle assembly to the motion control assembly.
7. Connect the seat pressure switch to the wire harness. Flip the seat down
and, using a 1/2 inch socket, install the 2 (5/16 inch) nuts and carriage bolts
to secure the rear of the seat to the chassis.
8. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
Figure 86
Figure 87
Page 6–22 2000 Series Z MASTER®Service Manual
3460-328 Rev A