Toro Z MASTER 2000 Series Service Manual page 77

ROPS Removal (continued)
ROPS Installation
2000 Series Z MASTER®Service Manual
3460-328 Rev A
g422383
6. Using a 3/4 inch wrench, remove the 2 (1/2 inch) lower shoulder bolts
securing the upper ROPS to the lower ROPS. Remove the upper ROPS
(note orientation).
7. Using a T40 torx driver, remove the 2 (5/16) screws securing the lower ROPS
to the rear guard assembly.
8. Using a 3/4 inch wrench, remove the 4 (1/2 inch) bolts securing the lower
ROPS to the chassis. Remove the lower ROPS.
g422384
1. Using a 3/4 inch wrench, install the 4 (1/2 inch) bolts to secure the lower
ROPS to the chassis. Install the lower ROPS.
g422384
Figure 70
Figure 71
Figure 72
Page 6–13 Chassis: Service and Repairs