Toro Z MASTER 2000 Series Service Manual page 110

Hydrostatic Transaxle Assembly Removal (continued)
Hydrostatic Transaxle Assembly Installation
Drive: Service and Repairs
g422385
11. Using a 1/2 inch socket, loosen the 8 lock nuts (4 per side) securing the
hydrostatic transaxle assembly to the chassis.
12. While supporting the hydrostatic transaxle, remove the 4 loosened nuts
from the chassis on one side. Remove the hydrostatic transaxle from the
machine. Repeat on the other side.
1. While supporting the hydrostatic transaxles, using a 1/2 inch socket, install
the 4 lock nuts to secure one of the hydrostatic transaxle to the chassis.
Repeat on the opposite side.
2. Install the spacer shaft. Using a 9/16 inch socket, install the 2 (3/8 inch) bolts
to secure the spacer shaft to the hydrostatic transaxle assembly. Torque
to 58 ± 7 N•m (43 ± 5 ft-lb).
g422385
3. Install the 2 cotter pins to secure the bypass rods to the hydrostatic transaxle
assembly.
4. Install the lower parking brake linkages. Install the 2 pins to secure the lower
parking brake linkages to the hydrostatic transaxle assembly.
Figure 116
Figure 117
Page 7–14 2000 Series Z MASTER®Service Manual
3460-328 Rev A