Toro Z MASTER 2000 Series Service Manual page 87

Right Hand Pod Removal (continued)
Right Hand Pod Installation
2000 Series Z MASTER®Service Manual
3460-328 Rev A
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Using a 9/16 inch socket, remove the 2 (3/8 inch) bolt securing the RH handle
assembly to the motion control assembly. Remove the RH handle assembly.
4. Remove the control panel. Refer to
5. Using a T30 torx driver, remove the 3 (1/4 inch) shoulder bolts securing the
RH pod to the chassis.
g432461
6. Using a T40 torx driver, remove the 2 (5/16 inch) bolts securing the RH rear
guard to the chassis. Remove the RH pod and RH rear guard.
1. Install the RH pod and RH rear guard.
Note: Lift the RH pod to allow the RH rear guard to seat into position.
2. Using a T40 torx driver, install the 2 (5/16 inch) bolts to secure the RH rear
guard to the chassis.
3. Using a T30 torx driver, install the 3 (1/4 inch) shoulder bolts to secure the
RH pod to the chassis.
g432461
4. Install the control panel. Refer to
Control Panel Removal (page
Figure 88
Figure 89
Control Panel Installation (page
Page 6–23
8–9).
8–12).
Chassis: Service and Repairs