Using A Vacuum Cleaner; Cleaning And Maintenance - Tesla AeroStar T700 Manual

USING A VACUUM CLEANER

Before using the appliance, first pull out a sufficient length of power cord and connect it to the mains
socket. The yellow mark on the network cable is the maximum length that must not be exceeded. To
switch on the device, press the On/Off button (6). To insert the mains cable back into the vacuum
cleaner, press the Cable rewind button (7). Hold the cord with one hand and guide it to avoid injury.
Use the Engine power regulator (8) to control the engine intake power.

CLEANING AND MAINTENANCE

Before cleaning, disconnect the mains plug from the mains socket. Clean the vacuum cleaner with a
damp cloth and then make sure it is dry. Do not use solvents or abrasive cleaners.
The maximum suction effect will always be achieved with clean HEPA filters and an empty dirt tank.
We also recommend cleaning the HEPA filters after each emptying of the tank. When vacuuming very
fine dust, the pores of the filters may become clogged. This can reduce air permeability and reduce
the suction power of the vacuum cleaner. Therefore, in such a case, it is advisable to clean the filters
even if the dirt tank is not yet full.
CLEANING THE INPUT AND OUTPUT HEPA FILTER
1. Switch off and unplug the vacuum cleaner.
2. Remove the dust tank from body of vacuum cleaner.
The universal floor nozzle with a pull-out brush is designed for all
types of floors. When vacuuming smooth hard surfaces, pull out
the brush and when vacuuming carpets, slide it in.
Crevice nozzle 2v1 - for radiators, corners, strips, etc.
Upholstery nozzle - for sofas, beds, upholstered armchairs, etc.