Table of Contents
Advertisement
Chapter 3 Cabinet Installation
Figure 3-21 Installing Plug-in Box
1. Fan box
2. M5 screw
3.7 Card Installation
This topic describes how to install a card.
Preparations
Perform the following steps to prepare for card installation:
1. Clean cards and shelves inside.
2. Take the card out of the antistatic bag.
3. Verify the card name according to the packing list.
4. Make sure that the card is not damaged and its components are complete.
5. Verify the software version of the card.
6. Make sure that conductive foam gaskets are installed properly.
Installing
Perform the following steps to install a card:
1. Wear the antistatic wrist strap.
2. Insert the card into the correct slot.
3. Press claspers on the card and push it in until it is latched, which means the card is in
place.
On the back of each shelf, there are floating grounding spring plates, which enable all
cards to be grounded.
3-21
SJ-20110909101511-005|2011-12-31 (R1.1)
ZTE Proprietary and Confidential
Advertisement
Table of Contents
