Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Zte WF832
Summary of Contents for Zte WF832
- Page 1 ZTE WF832 CDMA Fixed Wireless Terminal User Manual...
- Page 2 ZTE Corporation. The manual is published by ZTE Corporation. We reserve the right to make modifications on print errors or update specifications without prior notice.
-
Page 3: Table Of Contents
Contents 1 GENERAL INFORMATION ..........1 1.1 W ................ 1 ELCOME 1.2 S ............. 1 AFETY RECAUTIONS 1.3 C ........3 LEANING AND AINTENANCE 1.4 L ............3 IMIT ARRANTY 1.5 L ..........4 IMITATION OF IABILITY 1.6 D ..............4 ECLARATION 2 GETTING STARTED ............ - Page 4 3.2 A ............14 NSWERING A 3.3 C ............14 ETERING 3.4 O ............15 THER UNCTIONS 4 ACCESS INTERNET............16 5 TROUBLESHOOTING............ 17...
-
Page 5: General Information
1 General Information 1.1 Welcome Thank you for choosing the ZTE WF832 CDMA Fixed Wireless Terminal (FWT). 1.2 Safety Precautions Some electronic devices susceptible electromagnetic interference sent inadequately shielded; Try to use the terminal at least 20 cm away from TV sets, radio and other automated office equipment so as to avoid electromagnetic interference. - Page 6 Do not put other things on the terminal to avoid overlaying radiator. Please use original accessories or accessories approved by ZTE. Using any unapproved accessories may affect your FWT’s performance, damage your terminal or even cause danger to your body and violate related national regulations about telecom terminals.
-
Page 7: Cleaning And Maintenance
(c) Water or any other liquid damage. (d) Any unauthorized repair or modification. (e) Power surges, lightning damage, fire, flood or other events outside ZTE’s reasonable control. (f) Use of the product with any unauthorized third party... -
Page 8: Limitation Of Liability
1.5 Limitation of Liability ZTE shall not be liable for any loss of profits or indirect, special, incidental or consequential damages resulting from or arising out of or in connection with using this product, whether or not ZTE had been advised, knew or should have known the possibility of such damages. - Page 9 designed and manufactured not to exceed limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.
- Page 10 interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver.
-
Page 11: Getting Started
2 Getting Started 2.1 Unpacking Parts Quantity Terminal Ni-MH battery External power adapter Antenna Line User manual Certificate of quality CD with package 1,optional Data cable 1,optional 2.2 Technical Parameters Parameters Description Interface IS-2000,downward compatible with Protocol IS-95A/B Frequency Range 800MHz LED Display Power indicator/Battery indicator/... - Page 12 External Interface External power socket Data interface (DATA) Antenna connector (ANT) Phone/Call meter interface (PHONE FAX) Power Supply Input:230V (AC), 50/60Hz Output:+12V (DC) Voice Decoding 8K EVRC Dimensions 220 mm×140 mm×40 mm (W×H×D) (Exclude antenna) Battery 1500mAH Ni-Hi battery Continuous Standby Time: Approx.
-
Page 13: Appearance
22.3 Appearance 2.3.1 LED Indicator PWR (power) Indicator Indicator turns on when the outer power supply well. BATT (Battery) Indicator Indicator turns on when the phone is power supplied by battery. Indicator turns blinking when the battery is in low-voltage. Note: FWT may not work normally when the battery is in low-voltage. -
Page 14: Interfaces
PHONE (Off hook) Indicator Indicator turns on when the phone is hook off, it turns off when the phone is hook-on. DATA/FAX Indicator Indicator turns on when FWT is dealing with data service. RSSI (Signal strength) Indicator Indicator turns on when RF signal is normal. Indicator turns blinking when RF signal is weak. -
Page 15: Power Switch
2.3.3 Power Switch ZTE WF832 may be turned on by switch at the rear side of the FWT. Turn it to "∣" to power on, turn it to "О" to power off. 2.4 Installing To install ZTE WF832, please: 1. Connect a telephone to the PHONE interface. - Page 16 When using the terminal, please connect it with the external power adapter. Use the spare rechargeable battery of the terminal in case of power failure or when there is no available power socket nearby. With external power supply, the terminal will automatically check electricity quantity of the battery and charge the spare battery.
-
Page 17: Basic Operations
3 Basic Operations 3.1 Making a Call 3.1.1 Making a Domestic Call Make sure that ZTE WF832 and telephone connected properly. Off hook the handset of the telephone, and then type telephone number (add area code when making a long distance call) on the keypad of the telephone, the terminal will send it automatically within 4 seconds. -
Page 18: Answering A Call
3.3 Call Metering Connect the call meter’s interface to PHONE FAX interface of ZTE WF832, and then connect the phone to the call meter. Call meter will begin to count when the phone is connected successfully. -
Page 19: Other Functions
Note: This function is network-dependent; the rate of metering should be set at the outer call meter. 3.4 Other Functions The terminal supports call forwarding; call waiting and three-way call. Please consult with the network carrier for details. Note: This function is network-dependent. -
Page 20: Access Internet
4 Access Internet ZTE WF832 FWT supports the speed of 153.6 kbps Internet access through data cable. Before using Internet service, Please make sure that: 1． FWT and the computer connected well with data cable. 2． Run the "autorun.exe" file from the CD-ROM, which come with the FWT, to install the PC Dial-up Software If you use special USB data cable，... -
Page 21: Troubleshooting
5 Troubleshooting Fault Solution Check the installation of the No dialing tone after off-hook antenna, RSSI signal or restart The phone is not compatible The phone is buzzing after with FWT, change another off-hooking phone The system stops sending dial Hook on, and then hook off tone 50 seconds after again to make a call... - Page 22 Fault Solution power source and antenna are connected correctly. If there are no problems, please power off and re-start the FWT again.
Need help?
Do you have a question about the WF832 and is the answer not in the manual?
Questions and answers