Figure 2-3 Cabinet Inner Package - Zte ZXA10 C300 Installation Manual

Figure 2-3 Cabinet Inner Package

1. Cabinet
Perform the following steps to open the box.
a. Before unpacking, place the case horizontally upwards. Use unpacking pliers or
nail claw to remove iron corner-wrappers of the box and the nails in the cover.
The unpacking sequence is: Detach the top cover > Remove the front side plate >
Remove the side plates (two sides) > Remove the back side plate > Remove the
foam plates > Open the moisture-proof plastic film.
Open the box carefully to avoid any damage to the cabinet.
b. Remove the packing material such as foam cushion and aluminum foil bag on
cabinet. Hold the lower part of the wooden box and pull the cabinet slowly till it is
upright. Then, drag the box out slowly until it stands steady.
Make sure that at least five persons are present to handle this procedure.
c. Keys required for cabinet are packed in a plastic bag and hung on the handle
of the cabinet front door. Use the keys to open the front, rear, and side doors.
Check whether there are complete collection of plug-in units in the cabinet. Check
for cabinet cleanness, scratches, or loosened parts on the surface. Make sure
that cabinet interior is clean with reliable socket connection and clear markings.
Because the plug-in units are transported with the cabinet, their reinforcing mode,
SJ-20110909101511-005|2011-12-31 (R1.1)
Caution!
Note:
Chapter 2 Pre-Installation Preparation
2. Top cushion
2-9
ZTE Proprietary and Confidential