Ricoh IS760 Operating Instructions Manual page 73

Image scanner
Hide thumbs Also See for IS760:
Table of Contents

Advertisement

Message
Cannot continue
endorsing due to
the limit.
Cannot add any
more scanning
mode.
Cannot specify
any more scanning
area.
Double Feed has
occurred.
Do you want to
continue scan-
ning?
Set the originals
again and press
"Yes" to contin-
ue,
"No" to end.
Cannot rotate the
original.
Lower the resolu-
tion and scan
again.
Cannot perform
Combine in the
current resolu-
tion.
Set the resolu-
tion to over
n-
dpi and scan
again.
Possible Cause
• The number of figures
exceeded or dipped
from the values set for
the endorser counter.
• Maximum number of
the scanning modes is
registered.
• Maximum number of
the scanning areas is
registered.
• Double Feed (More
than 2 sheets of origi-
nal was fed into the
ADF at once) has oc-
curred and was de-
tected.
• Exceeded the maxi-
mum file size for the
rotate function.
• When combining the
images, the originals
will be scanned with
the lowest resolution
specified for the scan-
ner. The resolution
displayed on the mes-
sage will be the lowest
resolution available
for the combine func-
tion.
Required Action
• The number of the counter has ex-
ceeded the value set in [Digit:] under
the [Endorser] tab. Check the num-
ber of the originals and set [Start:],
[Step:], and [Digit:].
• The number of the counter has
reached -1 when you set [Step:] un-
der the [Endorser] tab to negative
value. Check the number of the
originals and set [Start:] and [Step:]
so the number of the counter ends in
higher values than 0.
• You can add a maximum of 100
scanning modes. Delete the modes
that you do not use.
• You can add a maximum of 100
scanning areas. Delete the areas that
you do not use.
• To continue scanning, replace the
double fed originals to the ADF and
Click [Yes]. Scanning restarts after
you click [Yes].
• To finish scanning, click [No].
• The double feeding is likely to occur
when the changeover switch is not
set correctly to the paper thickness
of the originals. When you scan the
regular thickness originals —origi-
nals thinner than 128g/m
(242.5bls)— set the switch on the
back side (regular paper mode).
• Lower the resolution or the set the
scan area smaller and scan again.
• Adjust the resolution to the dis-
played value.
Troubleshooting
6
2
69

Advertisement

Table of Contents
loading

This manual is also suitable for:

Is760d

Table of Contents