Connecting With Usb Interface - Ricoh IS760 Operating Instructions Manual

Setting up the Scanner

Connecting with USB Interface

Note
❒ Please use the recommended USB cable. Using other cables might occur an ir-
regular operation. As for the recommended cables, please ask your service
representative.
2
❒ You can connect the scanner to two computers at the same time. One with the
SCSI interface, and one with the USB 2.0 interface. Though, you cannot use
the scanner at the same time from two computers. Interfaces are switched au-
tomatically when you change from one of the computer to the other.
A A A A
Open the cover of the switch box on the lower left of the frontside of the
scanner.
Note
❒ Push the knob of the cover to the left and pull the cover to open.
B B B B
Confirm the DIP Switch No.2 is in the ON position.
Note
❒ If the DIP Switch No.2 is set to OFF, set it to ON. If the switch is set to OFF,
"Found New Hardware Wizard" will not start. .
❒ Press the Hard Reset Switch if you changed the DIP Switch while the pow-
er is ON. ⇒ p.34 "Using the Hard Reset Switch"
28
ADC015S
ADC080S