Table of Contents
Advertisement
Setting up the Scanner
G G G G
Connect the IEEE1394 interface board to the extension connector. Fix the
board with four accessory screws from inside, two accessory screws from
outside.
2
H H H H
Check that it is connected tightly, check that there are no foreign objects
such as metal on the scanner control unit.
I I I I
Close the scanner control unit cover and fix with seven screws, then insert
the scanner control unit into the main unit.
Note
❒ Be sure to place the scanner on the level surface when inserting the scanner
control unit.
❒ Insert the scanner control unit till you see the screw holes.
J J J J
Fix the scanner control unit with three screws.
K K K K
Removed cables must connect in former state.
20
ADC014S
Advertisement
Table of Contents
