Table of Contents
Advertisement
Setting up the Scanner
B B B B
Confirm the DIP Switch No.2 is in the ON position.
2
Note
❒ If the DIP Switch No.2 is set to OFF, set it to ON. If the switch is set to OFF,
"Found New Hardware Wizard" will not start. .
❒ Press the Hard Reset Switch if you changed the DIP Switch while the pow-
er is ON. ⇒ p.34 "Using the Hard Reset Switch"
C C C C
Connect the IEEE1394 cable to the IEEE1394 connector.
Note
❒ Connect the cable to either one of the connectors.
D D D D
Connect the other side of the cable to the IEEE1394 connector on your com-
puter.
E E E E
Repeat Steps
second computer.
30
ADC080S
ADC023S
C C C C
D D D D
and
with the other IEEE1394 connector to connect with a
Advertisement
Table of Contents
