Connecting With Ieee1394 Interface - Ricoh IS760 Operating Instructions Manual

C C C C
Connect the USB cable to the USB connector.
D D D D
Connect the other side of the cable to the USB connector on your computer.

Connecting with IEEE1394 Interface

Note
❒ The optional IEEE1394 interface board is required.
❒ An IEEE1394 cable is packed to be used for the optional IEEE1394 interface
board.
❒ An irregular operation might occur for the IEEE1394 interface board of some
PC. Please use the recommended IEEE1394 interface board for your PC. As
for the recommended boards, please ask you service representative.
❒ You can connect the scanner to three computers at the same time. One with a
SCSI interface, and two with the optional IEEE1394 interface. Though, you
cannot use the scanner at the same time from three computers. Interfaces are
switched automatically when you use any one of the computers.
A A A A
Open the cover of the switch box on the lower left of the frontside of the
scanner.
Note
❒ Push the knob of the cover to the left and pull the cover to open.
ADC022S
ADC015S
Connecting to the Computer
2
29