Connecting To The Pc; Connecting To The Scsi Interface - Ricoh IS330DC Setup Manual

Connecting to the PC

This unit has an interface that com-
plies with SCSI-2/3 standards and an
interface that complies with IEEE1394
standards (option). This explanation
describes the connection methods for
both types of interface.
Connecting to the SCSI
Interface
Important
When connecting this unit to other
SCSI devices through a daisychain,
possibly it doesn't work properly.
The SCSI interface of this unit is of
the 50-pin half-pitch (pin-type)
type. Connect a shielded SCSI-2
compliant with ANSI standards or
a SCSI-3 (Ultra-SCSI) cable.
It is possible that malfunction oc-
curs or data is lost when more than
one SCSI ID's exists simultaneous-
ly. Adjust the settings such that the
SCSI ID of this unit does not coin-
cide with the ID of another SCSI
device.
Keep the total length of the SCSI
cable including the cable inside the
PC to a maximum of 1.5m (4.9 feet)
when using the SCSI-3 (Ultra-SC-
SI) and 3m (9.8 feet) when using
the SCSI-2.
This unit may not work properly
in combination with other SCSI
boards or cables. If this is the case,
connect only this unit to the PC.
Setting the SCSI ID
A
Open the cover at the lower left of
the main unit.
B
Set the SCSI ID by rotating the
Rotary Switch.
0
Note
Press the Hard Reset Switch
when ch an ging the setting
while the power is switched on.
Connecting a SCSI cable
A
Switch off the power to the PC
a n d a l l d e v i c e s c o n n e c t e d
through the SCSI interface.
7,19   
Connecting to the PC
ZDLS010E
ZDLS030E
9
1