Advertisement
(3)
Install the dust wiper(8) to the gland(4) using a
special installing tool. Coat the dust wiper with
grease slightly before installing.
(4)
Using a special tool, install gland assembly into
the cylinder tube(1).
(5)
Using a hook spanner, install the gland(4) ass-
embly, and tighten it with torque 60 6kgf m
(434 43lbf ft).
(6)
After the gland(4) assembly was installed to the
cylinder tube(1), calk at the tube end into the
groove on the gland to prevent screw loosen-ing.
If it is needed to calk again, never calk on the
same place.
(7)
Move the piston rod back and forth several times
for the full distance of its stroke. This helps to
seat the ring and seals before applying full
hydraulic pressure to the cylinder.
(8)
Install cylinder into trail axle.
(9)
While idling the engine with the rear wheels off
the ground, operate the steering wheel left and
right alternately.
Then, repeat the above operation at gradually
increasing engine rpm. This releases air from
the system and completes preparation for
operation.
(10)
Stop the engine, lower the floating rear wheels,
and check pump joints for oil leaks and
looseness and retighten, them as required.
5-32
6
Special tool
D507SE29
Hook spanner
4
D507SE30
4
D507SE31
Advertisement
