Advertisement
11)
PREHEATER PILOT LAMP
77073CD14
12)
OPSS PILOT LAMP(OPTION)
160D7CD14
13)
INCHING PILOT LAMP
77073CD65
14)
ENGINE OIL PRESSURE WARNING LAMP
77073CD18
15)
T
T
RANSMISSION ERROR WARNING LAMP
77073CD19
(1)
This lamp lights ON when start switch is turned clockwise to the
ON position. Light will turn off after approximately 15~45
seconds, depending on engine temperature, indicating that
preheating is completed.
(2)
When the lamp goes out the operator should start cranking the
engine.
Refer to page 5-12 in operator's manual.
(1)
This signal lamp lights ON when the operator leaves the seat.
(2)
Powered travel movement of the truck shall be possible only if
the operator is in the normal operating position. Transmission
will automatically shift to neutral upon the exiting of the
operator.
(3)
The forward/Reverse lever must be cycled through neutral with
the operator in the normal operating position to regain powered
direction control.
(1)
When the inching switch is pressed, the lamp lights ON.
(1)
This lamp is comes ON for a while after starting the engine
because of the low oil pressure.
(2)
If the lamp comes ON during engine operation, shut OFF engine
immediately. Check oil level.
(1)
This lamp lights ON and the T/M message display shows the error
codes when an error occurs in the transmission.
(2)
Immediately pull the truck to a convenient stop. Stop the engine.
Investigate the cause.
Consult a HYUNDAI dealer to investigate the cause.
Do not operate until the cause has been corrected.
7-16
Advertisement
