Advertisement
3)
MOUNTING AND BASIC SETTING REGULATIONS
Basic brake setting is required after mounting new brake lining plates or brake disks, as well as
during all repair stages and in the event of insufficient braking performance.
1
Thrust bolt
2
Bank of cup springs
3
Adjusting screw
All mounting and basic setting work must be carried out on the brake when cold.
(1)
Mounting the brake
Stand the vehicle on an even surface and secure against rolling away.
Release the screw cap.
Release the lock nut(size 24 or 30) and turn the adjusting screw anticlockwise using a size 8 or
10 socket wrench until the pressure bolt comes to rest against the even surface of the piston. In
this status, the brake can be mounted onto the brake disk and fastened.
Mount the pressure connection again.
Apply the necessary release pressure to the brake until the bank of cup springs is completely
pre-tensioned. Following carry out the following page basic setting regulation.
2
1
P
5
S
4
Screw cap
5
Lock nut
6
Piston
4-13
6
3
4
P
Even surface
S
Socket wrench
100D7BS112
Advertisement
