Advertisement
1
Guide bolt
2
Lining pad
3
Lining pad
4
Permanent magnet
Depending on the free space available, release one of the two guide bolts, removing the safety
splint, unscrewing the castellated nut and pulling the guide bolt out of the brake anchor plate.
Now, the brake lining pads can be removed tangentially to the brake disk.
In the event of minimal clearance, i.e. it is not possible for space reasons to exchange the brake
lining plate in accordance with these instructions, the brake must be removed completely. To do
this, pull both guide bolts out of the brake anchor plate.
Check the pressure hose. If the pressure hose is to short, it must be unscrewed to remove
the brake. Before the pressure hose can be released the brake must be emergency
released.
Exchange the brake pads and insert the guide bolts into the brake anchor plate. If you have
removed the complete brake you have to amount the brake on both guide bolt again, now.
Check both permanent magnets if they still have sufficient magnetic force to hold the brake lining
plates. Should this not be the case, the permanent magnets must also be changed by using a
suitable screw driver.
Secure the guide bolt with the castellated nut and the safety splint respective safety clip.
After mounting new brake lining plates or their repair, the brake must be correctly set in
accordance with the instructions "Adjusting regulations".
6b
1
6a
3
4-17
1
4
5
2
5
Castellated nut
6a Safety splint
6b Safety clip
100D7BS114
Advertisement
