Advertisement
8)
ASSEMBLY OF THE DIFFERENTIAL
Before assembly all of the bevel gears and
the thrust rings should be well oiled.
(1)
Place one differential side gear with the
side gear thrust washer in the differential
case.
(2)
Install the spider with differential gears
and differential pinion thrust washers in
the differential case.
(3)
Install the other differential side gear and
side gear thrust washer.(At variants with
nospin differential install the nospin diff.
instead of the differential gears)
(4)
Install the other half of the differential case
over the assembly and observe the
alignment marks, tighten the differential
case bolts. Secure with Loctite 262.
(5)
Check that all differential pinions can
rotate easily.
(6)
Coat the contact surface of the ring gear
with Loctite 270 and install the ring gear
on the differential case by tapping lightly
on the circumference. Tighten the ring
gear bolts. Secure with Loctite 262.
(7)
Heat the two taper roller bearings to about
100
C and install them by using a sleeve.
3-128
100D7XL31
100D7XL32
100D7XL33
Advertisement
