Advertisement
(
(
4)
Installation of the external and internal
rotor
Install the external rotor.
Chamfer shows to the pump base
(cannot be seen in the picture).
Install the internal rotor.
Gearing(arrow) shows downwards.
Put on the cam disc and by means of two
cap screws(1) fasten it radially.
Do not tighten the cap screws - just turn
then in until contact is obtained and then
make approx. 1/2 rotation back.
Observe the installation position of the
cam disc.
Put the O-ring(2) into the annular groove
and oil it.
Mount the preassembled pressure oil
pump(1) and with the cap screws(3pcs.)
first place it equally until contact is
obtained.
Observe the radial installation position.
Then remove the cap screws again.
1
3-102
D507TM194
2
D507TM195
1
D507TM196
Advertisement
