Advertisement
FRONT WORKING SECTION
(1)
Locate the drive gear(10) and driven
gear(11) into the rear working section(17)
after fitting the parts of the pressure plate
into the drive gear.
Locate the pressure plate(9+8+7) with
care for the direction.
(2)
Fit the through shaft(15) into the drive
gear(10).
(3)
Insert the square ring(13) into the front
working section(14).
Smear clean grease on the square ring to
avoid drifting away of square ring from the
body.
(4)
Tighten the assembling bolts(3) with
washers(4) into the front working
section(14).
Tightening torque
Bolt : 28.6kgf m(207lbf ft)
(5)
Locate the drive gear(10) and driven
gear(11) into the front working section(14)
after fitting the parts of the pressure plate
into the drive gear.
Locate pressure plate(9+8+7) with care
for the direction.
15
14
4
3
9
8
7
10
11
6-42
10
11
17
100D7PMP10
17
13
100D7PMP11
14
7
8
100D7PMP04
Advertisement
