Hyundai 100D-7 Operating Manual page 190

12) Assembly of the planetary housing
Place O-ring(30) into the slot of the planetary housing. Install the planetary housing and bolt it.
Adjustment of the axial clearance
13)
The axial clearance between axle shaft respective universal joint and adjusting screw must be
0.3~0.7mm. The adjustment has to be made by screwing in the adjusting screw until it touches the
axle shaft respective universal joint. Back-off the adjusting screw 72~170
position(this corresponds to about 0.3~0.7mm axial clearance).
Secure the adjusting screw and the counter nut with Loctite 270.
When tightening the counter nut(29), hold the adjusting screw unconditional, to prevent turning of
the adjusting screw.
3-142
100D7XL72
from the tightened