Remote Voltage/Amperage Control - Miller Big Blue Duo Pro 700 X Owner's Manual

6-9.

Remote Voltage/Amperage Control

1-1. Voltage/Amperage Control With 14-Pin Remote Accessory
2 3
Big Blue 800 Duo Air Pak shown.
CC Welding
56
CV Welding
28
�
Complete Parts List is available at www.MillerWelds.com
Complete Parts List available at www.MillerWelds.com
1
2 3
1
205
205
0
1 Remote Receptacle
277074-C
Connect optional remote control to
receptacle.
1 Remote Receptacle
When a remote control is con-
nected to the Remote recep-
Connect optional remote control to recep-
tacle, the Auto Remote Sense
tacle (see Section 5-9).
feature automatically switches
� voltage/amperage control to the
When a remote control is connected to
remote control. When a device is
the Remote receptacle, the Auto Re-
connected to the Remote recep-
mote
tacle, remote voltage/amperage
switches voltage/amperage control to
control is always available re-
the remote control. When a device is
gardless of the position of the
Process/Contactor switch. connected to the Remote receptacle,
remote voltage/amperage control is al-
2 Voltmeter
ways available regardless of the posi-
3 Ammeter
tion of the Process/Contactor switch.
CC Welding
2 Voltmeter
Connect remote control to remote re-
ceptacle. Set TIG or STICK process.
3 Ammeter
Turn remote control On. Adjust op-
tional remote control to 100%.
CC Welding
Voltmeter shows open-circuit volt-
Connect remote control to remote recep-
age when not welding, arc voltage
tacle. Set TIG or STICK process.
while welding.
Ammeter shows preset output when
Turn remote control On. Adjust optional re-
not welding, actual amperage while
mote control to 100%.
welding.
Set V/A control to desired maximum
Voltmeter shows open-circuit voltage when
weld output using weld meters.
not welding, arc voltage while welding.
Adjust optional remote control to de-
sired weld output (max 205 A DC, Ammeter shows preset output when not
min 20 A DC).
welding, actual amperage while welding.
CV Welding
Set V/A control to desired maximum weld
Connect remote control to remote re-
output using weld meters.
ceptacle. Set WIRE process.
Adjust optional remote control to desired
Output On: Voltmeter toggles be-
tween preset and actual output when
weld output (max 205 A DC, min 20 A DC).
not welding, actual voltage while
welding.
CV Welding
Remote On/Off Required: Voltage
Connect remote control to remote recep-
shown is preset.
tacle. Set WIRE process.
Ammeter shows zero.
Output On: Voltmeter toggles between pre-
Adjust optional remote control to de-
sired weld output.
set and actual output when not welding, ac-
tual voltage while welding.
Remote On/Off Required: Voltage shown is
preset.
Ammeter shows zero.
Adjust optional remote control to desired
weld output.
0774 / Ref.272 446-B / Ref. 907 695
Sense feature automatically
OM-279640 Page 1
OM-282302 Page 47