Voltage/Amperage Control With 14-Pin Remote Accessory - Miller Big Blue 500 Pro Owner's Manual

6-10. Voltage/Amperage Control With 14-Pin Remote Accessory

CC Welding
In Example:
Min = 20 A DC
Max = 205 A DC
Connect Remote
Control To Remote
Receptacle
CV Welding
Output On: Voltmeter toggles
between preset and actual
output when not welding, ac-
tual voltage while welding.
Remote On/Off Required:
Voltage shown is preset.
Connect Remote
Control To Remote
Receptacle
OM-278739 Page 38
.
Complete Parts List available at www.MillerWelds.com
3
2
1
Voltmeter Shows Open-Circuit
Voltage When Not Welding, Arc
Set TIG or STICK Process
28
Set WIRE Process
Voltage While Welding
Turn Remote Control On. Ad-
just Optional Remote
Control to 100%
0
Ammeter Shows Zero
Adjust Optional Remote
Control to desired
weld output
1 Remote Receptacle
Connect optional remote control to
receptacle (see Section 5-9).
.
When a remote control is con-
nected to the Remote recep-
tacle, the Auto Remote Sense
feature automatically switches
voltage/amperage control to
the remote control. When a de-
vice is connected to the Re-
mote receptacle, remote volt-
age/amperage control is al-
ways available regardless of
the position of the Process/
Contactor switch.
2 Voltmeter
3 Ammeter
85 205
Ammeter Shows Preset
Output When Not Welding,
Actual Amperage While
Welding
Set V/A Control
To Desired Maximum
Weld Output Using Weld
Meters
Max (205 A DC)
Min (20 A DC)
Adjust Optional Remote
Control to desired
weld output
0774 / Ref.272 446-B / Ref. 907 695