Making Dual Operator Cv Weld Connections W/ Separate Work Cables - Miller Big Blue Duo Pro 700 X Owner's Manual

5-12. Making Dual Operator CV Weld Connections w/ Separate Work Cables

1
3/4 in.
Stop engine.
wrench
crescent wrench
NOTICE – Do not exceed machine duty
cycle.
�
Use Dual Operator mode for CC and
CV welding (see Section 6).
�
Direct Current
(DCEP) connections are shown.
nutdriver
chippinghammer
wirecutter frontcutter
�
Complete Parts List is available at www.MillerWelds.com
See Selecting Cable Size table for proper
cable size.
1 Wire Feeder Cables
2 Work Cables
For MIG and FCAW welding Direct Current
Electrode Positive (DCEP), connect work
Electrode Positive
cables to Negative (-) terminals and wire
feeder cables to Positive (+) terminals.
1
2
For MIG and FCAW welding Direct Current
Electrode Negative (DCEN), connect work
cables to Positive (+) terminals and wire
feeder cables to Negative (-) terminals.
�
2
Ref. 251 340-A / Ref. 802 292-A
Be sure Process Selector switches are
set correctly. See Section 6-3.
OM-282302 Page 29
OM-282302 Page 35