Table of Contents
Advertisement
4-1.
Serial Number And Rating Label Location
The serial number and rating information for this product is located on the front. Use rating label to determine input power requirements and/or
rated output. For future reference, write serial number in space provided on back cover of this manual.
4-2.
Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula
4-3.
Information About Default Weld Parameters And Settings
NOTICE – Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical
welding parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are
for reference purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriate-
ness of all parameters and settings should be evaluated and modified by the end user as necessary based upon application-specific require-
ments. The end user is solely responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld
parameters and settings, and ultimate quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warran-
ties including any implied warranty of fitness for a particular purpose.
4-4.
Weld, Power, And Engine Specifications
�
This equipment will deliver rated output at an ambient air temperature up to 104°F (40°C).
Welding Mode
CC/DC (Stick) Paralleled
(combined)
CC/DC (Stick) Separate (dual
outputs)
CC/DC (TIG) Paralleled
(combined)
CC/DC (TIG) Separate (dual
outputs)
CV/DC (MIG/FCAW) Paralleled
(combined)
CV/DC (MIG/FCAW) Separate
(dual outputs)
Generator Power Rating
Standard Power: 4000 Watts
Continuous
3 phase Power: 20,000 Watts
Continuous
4-5.
Environmental Specifications
A. IP Rating
This equipment is designed for outdoor use. It may be stored, but is not intended to be used for welding outside during precipitation unless
B. Temperature Specifications
Operating Temperature Range*
–40 to 104°F (–40 to 40°C)
*Output is derated at temperatures above 104°F (40°C).
OM-282302 Page 20
�
Complete Parts List is available at www.MillerWelds.com
SECTION 4 – SPECIFICATIONS
and are incorporated by reference herein.
Weld Output Range
40–800 A
20–400 A Each Side
40–800 A
20–400 A Each Side
13–50 V
13–50 V Each Side
Engine
Deutz D2011L04i Air/Oil-Cooled,
Four Cylinder, 48.7 HP Diesel
Engine
Rated Welding Output
500A at 40V, 100% Duty Cycle*
550A at 42V, 60% Duty Cycle*
275A at 31V, 100% Duty Cycle*
550A at 32V, 100% Duty Cycle
625A at 34V, 60% Duty Cycle*
275A at 22V, 100% Duty Cycle
500A at 39V, 100% Duty Cycle
550A at 41.5V, 60% Duty Cycle*
275A at 28V, 100% Duty Cycle*
Fuel Tank Capacity
25 gal (95 L)
IP Rating
IP23S
sheltered.
Storage/Transportation Temperature Range
–40 to 131°F (–40 to 55°C)
Maximum Open-Circuit Voltage
85 VDC
Sound Level At Rated Output
23 ft (7 m): 75 dB (100 Lwa)
Advertisement
Table of Contents
Troubleshooting
