5-10. Making Dual Operator CC Weld Connections w/ Separate Work Cables
4-1. Making Dual Operator CC Weld Connections w/ Separate Work Cables
1
3/4 in.
Stop engine.
wrench
crescent wrench
NOTICE – Do not exceed machine duty
cycle.
�
Use Dual Operator mode for CC and
CV welding (see Section 6).
�
Direct
Current
(DCEP) connections are shown.
nutdriver
chippinghammer
wirecutter
frontcutter
�
Complete Parts List is available at www.MillerWelds.com
See Selecting Cable Size table for proper
cable size.
1 Electrode Holder Cables
2 Work Cables
For Stick/TIG welding Direct Current Elec-
trode Positive (DCEP), connect work cables
Electrode
Positive
to Negative (-) terminals and electrode hold-
er cables to Positive (+) terminals.
2
For Stick/TIG Direct Current Electrode Neg-
ative (DCEN), connect work cables to Posi-
tive (+) terminals and electrode holder
cables to Negative (-) terminals.
�
1
Ref. 251 340-A / Ref. 802 292-A
Be sure Process Selector switches are
set correctly. See Section 6-3.
OM-282302 Page 27
OM-282302 Page 33