Section 5 - Installation; Installing Welder/Generator - Miller Big Blue Duo Pro 700 X Owner's Manual

5-1.

Installing Welder/Generator

Movement And Airflow Clearance
Location/Mounting
9/16 in.
�
wrench
Go to MillerWelds. com for more infor- crescent wrench
mation on truck installations.
Movement
Do not move or operate unit where it
could tip.
�
See Specifications for lifting eye rating.
Airflow Clearance
NOTICE – Do not install unit where air flow
nutdriver
is restricted or engine may overheat.
chippinghammer
Location/Mounting
Always securely fasten welding gen-
erator onto transport vehicle or
trailer and comply with all DOT and
other applicable codes.
wirecutter frontcutter
�
Complete Parts List is available at www.MillerWelds.com
SECTION 5 – INSTALLATION
2
2
1
Do not weld on base. Welding on
base can cause fuel tank fire or ex-
plosion. Weld only on the four
mounting brackets or bolt unit
down.
NOTICE – Do not mount unit by supporting
the base only at the four mounting brackets.
Use cross-supports to adequately support
unit and prevent damage to base.
1 Cross-Supports
2 Mounting Brackets (Supplied)
Mount unit on flat surface or use cross-sup-
ports to support base. Secure unit with
mounting brackets.
18 in.
18 in.
(460 mm)
(460 mm)
18 in.
18 in. (460 mm)
(460 mm)
3
4
1
3 1/2 in. Bolt And Washer (Minimum - Not
Supplied)
4 3/8-16 x 1 in. Screws (Supplied)
To Bolt Unit In Place:
Remove hardware securing the four mount-
ing brackets to the base. Reverse brackets
and reattach to base with original hardware.
Mount unit to truck or trailer with 1/2 in. (12
mm) or larger hardware (not supplied).
To Weld Unit In Place:
Weld unit to truck or trailer only at the four
mounting brackets.
18 in.
18 in.
(460 mm)
(460 mm)
18 in.
18 in.
(460 mm)
(460 mm)
18 in.
18 in.
(460 mm)
(460 mm)
OM-282302 Page 27