Remote Voltage/Amperage Control - Miller Big Blue Air Pak 600 Owner's Manual

6-9. Remote Voltage/Amperage Control

1
CC Welding
In Example:
Min = 20 A DC
Max = 205 A DC
Connect remote
control to remote
receptacle RC14
CV Welding
Electrode Hot: Voltmeter tog-
gles between preset and ac-
tual output when not welding,
actual voltage while welding.
Remote On/Off Required:
Voltage shown is preset.
Connect remote
control to remote
receptacle RC14
.
Complete Parts List available at www.MillerWelds.com
2 3
Voltmeter shows open-circuit
voltage when not welding, arc
Set TIG or STICK Process
28
Set WIRE Process
1 Remote 14 Receptacle
Connect optional remote control to receptacle
(see Section 5-10).
.
When a remote control is connected to the
Remote receptacle, the Auto Sense Re-
mote feature automatically switches volt-
age/amperage control to the remote con-
trol. When a device is connected to the Re-
mote receptacle, remote voltage/amper-
age control is always available regardless
of the position of the Process/Contactor
switch.
2 Voltmeter
3 Ammeter
voltage while welding
Turn remote control on.
Adjust optional remote
control to 100%
0
Ammeter Shows Zero
Adjust optional remote
control to desired
weld output
85 205
Ammeter shows preset
output when not welding,
actual amperage while
welding
Set V/A Control
to desired maximum
weld output using weld
meters
Max (205 A DC)
Min (20 A DC)
Adjust optional remote
control to desired
weld output
0774 / Ref.246 345-B / Ref. 907712
OM-275624 Page 39