Making Single Operator Cc Weld Connections - Miller Big Blue Duo Pro 700 X Owner's Manual

5-16. Making Single Operator CC Weld Connections

2
3/4 in.
Stop engine.
wrench
crescent wrench
NOTICE – Do not exceed machine duty
cycle.
�
Use Single Operator mode for CC
welding only. Welder B weld output ter-
minals are disabled in Single Operator
mode (see Section 6).
nutdriver
chippinghammer
wirecutter frontcutter
�
Complete Parts List is available at www.MillerWelds.com
1
�
Direct Current
(DCEP) connections are shown.
See Selecting Cable Size table for proper
cable size.
1 Electrode Holder Cable
2 Work Cable
For Stick/TIG welding Direct Current Elec-
trode Positive (DCEP), connect work cable
to Negative (-) terminals and electrode hold-
Electrode Positive
er cable to Positive (+) terminals.
For Stick/TIG welding Direct Current Elec-
trode Negative (DCEN), connect work cable
to Positive (+) terminals and electrode hold-
er cable to Negative (-) terminals.
�
Be sure Process Selector switch is set
correctly. See Section 6-3.
Ref. 251 340-A / Ref. 802 292-A
OM-282302 Page 33
OM-282302 Page 39