Associating Arcreach; Devices (Arcreach Models Only) - Miller Big Blue Duo Pro 700 X Owner's Manual

6-13. Associating ArcReach

Stop engine.
NOTICE – Do not exceed machine duty cycle.
Associating ArcReach Device To Engine Driven Welder/Generator
Make connections between welder/generator and ArcReach device. See Owner's Manual for ArcReach device for typical connection
diagrams.
The welder/generator has the ability to associate automatically with an ArcReach device at power up. The Process/Contactor switch must be
set to an Output ON mode to associate with an ArcReach device.
See the ArcReach device Owner's Manual to associate the device to the welder/generator.
When the association process is complete, the In Use light will be illuminated. Depending on the capabilities of the ArcReach device, the Proc-
ess/Contactor switch, Adjust Control/Select button, and Arc Control adjustment may be overridden.
The following ArcReach accessories are compatible with this welder/generator:
ArcReach Stick/TIG Remote
For Stick Or TIG Welding
When welder/generator is associated with
Stick/TIG Remote:
SMAW processes: Amperage, Electrode
Type, and Arc Control settings are adjusted
on the remote.
GTAW and CAC-A processes: Amperage set-
tings are adjusted on the remote.
�
Complete Parts List is available at www.MillerWelds.com

Devices (ArcReach Models Only)

®
ArcReach SuitCase Feeders
For MIG Or FCAW Welding
When welder/generator is associated with
SuitCase ArcReach feeder, voltage and wire
feed settings are adjusted on the feeder.
ArcReach Smart Feeder
For Advanced Wire Processes
274460-A / 266206-D
274460-A / 266206-D
274460-A / 266206-D
When welder/generator is associated with
Smart Feeder, all controls switch to the
feeder, and the display reads SMRT ACC.
�
When using this ArcReach device, the
engine will stay at RUN speed.
OM-282302 Page 51