Proximus Forum Free 568 User Manual page 51

Please note that to ensure dependable functioning, the device should be worn
(belt clip) as exposed as possible (not in your pocket).
Mandown
Usually the mobile unit is worn vertically, e.g. with the belt clip directly
fastened to the person's body. The position measurement is conducted
continuously and checks to ensure the device is still upright. If the device is
45° from being in the vertical, an alarm is triggered after a defined time
interval, as there may be an emergency.
No movement
This alarm is triggered when the mobile unit is motionless for a definable time
interval (no device movement or movement of the person wearing the
device). Sensor sensitivity can be configured in three levels. It is recommended
to test the sensitivity of the no movement alarm with the person being
monitored in order to guarantee reliable operation.
When loading the device in the charger or via the USB port, the no movement
alarm is deactivated.
Escape
The escape alarm is triggered when the sensor detects intense movements of
the mobile unit during a configurable time interval. As with the no movement
alarm, the sensor sensitivity can be set at three levels. It is recommended to
test the sensitivity of the escape alarm with the person being monitored in
order to guarantee reliable operation.
Setting alarm times
The settings are in the
Alarm times are comprised as follows:
Delay: This is the time that starts after the triggering event (mandown, no
movement, escape). If the triggering event is interrupted for at least
2 seconds during this time, the delay restarts.
The delay can be configured separately for each alarm type.
Pre alarm: This is the time where – if activated – an alarm tone is signalled on
the mobile unit before the alarm call number is dialled. To switch off the
alarm tone (and thus deactivate the alarm), you have to press the
Esc softkey. During pre-alarm, a display shows how much time remains
until the alarm call number is dialled.
If the triggering event is interrupted for at least 4 seconds (2 seconds
for the no movement alarm) during this time, the delay restarts.
Basic Functions
> Security > Alarm Sensor menu (see page 138).
Special Functions
49