Table of Contents
Advertisement
"Settings" Menu
Auto answer (call): This function has the mobile unit automatically
accept a call. You only activate this feature if your work proce-
dures necessitate it, as it could enable a caller to listen in without
your noticing. To be on the safe side, the automatic call
acceptance is introduced with 3 notification tones and a quickly
blinking green LED signals the connection.
The function is useful for being immediately informed of
important things (e.g. when on call). In addition, when operating
the mobile unit, this function can be used more easily with a
headset. Press
The following options can be configured:
Time: you can set the length of time after which a call is auto-
Handsfree: the call can be accepted in the handsfree mode
Microphone: the call can be accepted automatically with or
LED indications: this is for switching the LED display on or off
Attention tone: the notification tone at the begin of the auto-
Auto quick hook: if this feature is activated, this destination is immedi-
ately dialled by pressing and holding a speed dial key (see
page 100). The prerequisite is that the associated phone book
entry only contains one destination (personal, office, mobile, e-
mail or fax). Otherwise the list of the entries is provided in pre-
dialling.
136
Change to switch on or off.
matically accepted: 0 sec ... 20 sec.
Please note: if your device supports the text messages
and / or paging features, do not enter a value any less
than 3 seconds.
(loudspeaker is activated). Using the setting In charger
only or Always differentiates whether or not handsfree is
switched on only when the mobile unit is in the charger or
whether it is also switched on when, e.g. it is being carried.
without the microphone switched on. The microphone can,
however, be switched on with the
the call.
during a connection.
matic call acceptance can switched on or off with this.
softkey after taking
The Device Menu
Advertisement
Table of Contents
