Connection To Zeiss Visuconsult/I.com Mobile; Fig. 12 Settings For Connection To Zeiss Visuconsult/I.com Mobile - Zeiss VISUREF 150 User Manual

Connection to ZEISS VISUCONSULT/i.Com mobile

Connect the device to your network. To do this, plug the network cable
•
(8, Fig. 1) into the relevant socket (8, Fig. 5).
Enable the interface in the Interface/Interface enablement menu (see
•
Section Interface submenu, page 95).
Open VISUCONSULT 500 and note the IP address of your i.Com server.
•
Open the Interface/LAN/Network socket menu (see Interface
•
submenu, page 95).
Enter the IP address of your i.Com server into the "Peer address/ID" field.
•
Select "XML ZEISS" as output format and "i.Com mobile" as output
•
protocol (see Fig. 12).
Fig. 12 Settings for connection to ZEISS VISUCONSULT/i.Com mobile
Exit the device settings and tap Apply.
•
VISUREF 150 is now enabled to send data to ZEISS i.Com mobile or
•
VISUCONSULT 500.
Initial start-up
000000-2227-967-GA-GB-281021
33