Fig. 35 Display Of Measurement Values Of A Single Measurement With - Zeiss VISUREF 150 User Manual

Fig. 35 Display of measurement values of a single measurement with changed illumination
parameters
The parameter control panel can also be used in the review screen (if this
•
function has not been disabled by device settings). Tapping on the panel
(6, Fig. 33) in the lower navigation bar will instantaneously display the
measurement values in a different notation or convert them on the basis
of the selected parameters.
– Depending on the selection of the output unit of keratometry, the user
interface shows the R1 or R2 corneal curvature values in mm or the
K1 or K2 values for corneal refraction in diopters.
The measurement is now completed by one of the following actions:
•
– Close the measurement by tapping on Finish. Further notes on this
are to be found in Section Output of measurement results, page 84.
– Discard the measurement by tapping on Delete. Further notes on this
are to be found in Section Delete measurement data, page 82.
– Return to the measurement screen by tapping on Measure.
Operation of the device
000000-2227-967-GA-GB-281021
63