Corporate And Personal Directory Setup - Cisco 8831NR Administration Manual

Corporate and Personal Directory Setup

Feature
UCR 2008
Voice Message System
Wideband Ringtone
Wireless Microphone Frequency
Lock
Corporate and Personal Directory Setup
The Contacts softkey on the conference phone gives users access to directory features. These directories can
include:
• Corporate Directory: Supports a global corporate directory that users can access on the conference phone
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
88
Description
The conference phone supports Unified Capabilities
Requirements (UCR) 2008 by providing support
for 80-bit SRTCP Tagging.
As an administrator, you must set up specific
parameters in Cisco Unified Communications
Manager Administration.
Enables callers to leave messages if calls are
unanswered.
The Wideband Ringtone feature supports 10
ringtones: 4 embedded in the phone firmware and
6 downloaded from the Cisco Unified
Communications Manager.
Provides a secure DECT frequency for wireless
microphones by locking down the Wireless Region
setting.
to lookup phone numbers of coworkers. You must enable and configure the corporate directories before
they can be used.
Features, Templates, Services, and User Setup
Configuration Reference
See UCR 2008 setup.
For more information, see the following:
• Cisco Unified Communications
Manager Administration Guide,
"Cisco Voice-Mail Port Setup"
• Cisco Unified Communications
Manager System Guide, "Voice Mail
Connectivity to Cisco Unified
Communications Manager"
For more information, see the following:
• Cisco Unified Communications
Manager Administration Guide,
"Directory Number Setup"
• Features and Services Guide for Cisco
Unified Communications Manager,
"Custom Phone Rings"
No configuration required for Firmware
release 10.3(1) and later. Earlier releases
must upgrade to the current release to have
the region setting locked.
Once you have configured the
Note
Wireless Region setting, it
cannot be updated. Further
configuration of this setting
requires an RMA.