Phone Setup - Cisco 7832 Manual

Your Phone
Table 5: Cisco IP Conference Phone 7832 User Guide Revisions for Firmware Release 12.1(1)
Revision
Support for Mobile and Remote Access
Through Expressway
Support for CMC and FAC

Phone Setup

Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.
Ways to Provide Power to Your Conference Phone
Your conference phone needs power from one of these sources:
• Power over Ethernet (PoE), which your network supplies.
• Cisco IP Phone Power Injector.
• A PoE Power Cable and Power Cube 3.
Note
The PoE power cable is not currently available.
The following figure shows the PoE and PoE power cable power options.
Figure 1: Conference Phone Power Options
Connect to the Network
You need to connect the phone to the network.
• Wired network connection—The phone is plugged into the network with an Ethernet cable.
After connecting the phone to the network, your phone may be set up for:
• Mobile and Remote Access Through Expressway—If your administrator sets up Mobile and Remote
Access Through Expressway and you connect your phone to the network, it connects to the Expressway
server.
New or Updated Section
• Connect to the Network, on page 5
• Connect to Expressway, on page 6
Calls That Require a Billing Code or Authorization Code
Phone Setup
Your Phone
5