Cisco 8831NR Administration Manual page 103

Features, Templates, Services, and User Setup
Table 28: Recording Tone Parameters
Parameter
Recording Tone Local Volume
Recording Tone Remote
Volume
Recording Tone Duration
Enable Recording Tone
Before you begin
You must be familiar with the Recording Tone parameters before you enable this feature.
Note You may want to notify your users if you enable this option. The default setting is Disabled.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, go to Device > Phone.
Step 2 Select Enable from the pulldown menu In the Recording Tone section.
Step 3
Enter a value between 0 and 100 per cent in the Recording Tone Local Volume field.
Step 4 Enter a value between 0 and 100 per cent in the Recording Tone Remote Volume field.
Step 5
Click Save.
Note
Indicates the volume for the recording tone that the local party receives, if
the local party phone has the Recording Tone option enabled.
This setting applies for each listening device, including the handset,
speakerphone, and headset.
Range: 0 percent (no tone) to 100 percent (same level as current volume
setting on the phone).
Indicates the volume for the recording tone that the remote party receives.
The remote party is the party who is on a call with the party whose phone
has the Recording Tone option enabled.
Range: 0 percent to 100 percent. (0 percent is -66 dBM and 100 percent is
-3 dBM).
Default: 50 percent.
Indicates the length of time in milliseconds that the tone plays.
If the value is less than one third of the interval, this value overrides the
default provided that the Network Locale provides.
Range: 0 to 3000
Note For some Network Locales that use a complex cadence, this setting
applies only to the first recording tone.
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
Enable Recording Tone
93