Cisco 8831NR Administration Manual page 78

Set TFTP Server 2
Set TFTP Server 2
Procedure
Step 1 Choose Apps > Admin Settings > Network Configuration > TFTP Server 1.
Step 2
Press Edit and enter an IP address for the TFTP Server 1 option.
Step 3 Press Apply, and then press Save.
Step 4 Choose Apps > Admin Settings > Network Configuration > TFTP Server 2.
Step 5 Choose the TFTP Server 2 option, and then press Edit.
Step 6 Enter a new backup TFTP server IP address.
Step 7
Press Apply, and then press Save.
Related Topics
DHCP Usage
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP addresses to devices when you connect
them to the network. Conference stations enable DHCP by default.
If you are configuring the Ethernet network settings on the phone for an IP network, you can set up an IP
address for the phone by either using DHCP to assign it for you or by manually entering an IP address.
Note
You must also enter the domain name for the phone in the Ethernet Setup page.
Set Up IP Phone to Use DHCP
To enable DHCP and allow the DHCP server to automatically assign an IP address to the Cisco Unified IP
Phone and direct the phone to a TFTP server, perform these steps:
Procedure
Step 1
Press Apps and choose Admin Settings > Network Setup > Ethernet Setup > IPv4 Setup.
Step 2 To enable DHCP, set DHCP Enabled to Yes. DHCP is enabled by default.
Step 3 To use an alternate TFTP server, set Alternate TFTP Server to Yes, and enter the IP address for the TFTP
Server.
Note
Step 4 Press Apply, and then press Save.
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
68
Set TFTP Server 1, on page 67
Consult with the network administrator to determine whether you need to assign an alternative TFTP
server instead of using the TFTP server that DHCP assigns.
Cisco Unified IP Conference Phone Settings